Clearing Blockages - Vax U90-P5 Series Instruction Manual

U90-P5 & U90-P6 Series User Guide v1.2.qxd:UG
7. Belt and Brush:
Removal and Replacement
1. Unplug the vacuum cleaner from the mains supply. Press
the handle release button and turn the vacuum cleaner
over so that the base lies flat and face up. Use a
screwdriver to remove the four retaining screws shown
above. Remove the nozzle guard (Fig.7/1).
Fig.7/1
Lift and remove the brushbar, then slide the belt off the
motor shaft and dispose of it. Place a new belt on the
motor shaft and then slip the brushbar through the belt
(Fig.7/2).
Fig.7/2
The belt should sit on the section of the brushbar without
bristles. Re-fit the brushbar. Ensure the end caps are in the
correct position. Rotate the brushbar to check the belt is
not twisted. Replace the nozzle guard.
13/5/10 14:46 Page 9
Vax Careline: (UK) 0844 412 8455 (ROI) 1-800 928 308

8. Clearing Blockages

WARNING: To reduce the risk of injury from
!
moving parts, unplug before servicing.
1. Check to see if dirt container is full. Empty and clean the
dirt container filter.
2. Unwrap the hose from the caddy. Remove any
obstruction if visible in the end of the hose (Fig.8/1).
Fig.8/1
2. Undo the hose from the back panel dirt tube. Remove
any obstruction (Fig.8/2).
Fig.8/2
3. To aid blockage removal, the hose can be removed by
pulling gently down and away from the body of the
machine.
4. Push a broom handle or other similar implement through
the hose to clear any obstructions (Fig.8/3).
Fig.8/3
belt and brush / clearing blockages
9