Maintenance; Replacing Disposable Odor Fighting Dust Bag; Replacing Worn Belt; Adjusting Or Replacing Brushroll - Oreck PLATINUM PILOT 79053-01REVA User Manual

Maintenance

E

Replacing Disposable Odor Fighting Dust Bag

WARNING: Unplug cord from electrical outlet before servicing.
BAG REMOVAL:
8
Unzip outer bag completely.
9
Pull bag cardboard collar to release bag dock door from connector. Bag dock door will hinge downward.
10 Gently pull bag cardboard collar upward out of the bag dock. Saniseal
BAG INSTALLATION:
11 Slide the cardboard collar completely onto bag dock door.
Firmly push bag dock door with both thumbs on indication point until it snaps.
12

Replacing Worn Belt

WARNING: Unplug cord from electrical outlet before servicing.
13
Remove the replacement belt from the storage channel.
14 Remove the door by removing the hold down screw located on side of power head.
Fold door away from the power head and lift it away.
15
Remove the belt from the motor drive shaft and brush roll pulley.
16
Loop the new belt over the brush roll pulley. Place the opposite end of the belt on the motor drive shaft.
17
Replace the door by placing the bottom tab on door into slots located inside power head and pressing the
18
door closed.
Replace the hold down screw and tighten.
19
13 14

Adjusting or Replacing Brushroll

WARNING: Unplug cord from electrical outlet before servicing.
Your Oreck Vacuum comes with the brush roll set at the "NORMAL" position for most types of carpets.
When using vacuum primarily on Berber Carpets, you can adjust brushroll to the "SPECIAL" setting for
increased performance.
20 Remove the base plate by removing 5 screws. Then, remove the belt and brushroll from the housing.
21 Rotate both end cards of the brush roll to show "SPECIAL" and replace in the holding channels of the housing.
Note: The one marked "SPECIAL" has several ribs on top of the end card.
22
The brush end card setting marked "NORMAL" has one rib. When rotating bearings, make sure both end card
23
assembly settings are the same and face up when replacing the brushroll.
Reassemble the belt.
24
Reassemble the baseplate.
25
6
N G L I S H
8
19 15
®
dust seal will close automatically.
9 10 11 12
16 17
ENFONCEZ JUSQU'À
ENTENDRE UN BRUIT
PRESIONE HASTA
ESCUCHAR UN
CHASQUIDO DE SUJECIÓN
18