Operating Instructions - Oreck DutchTech DTX 1300 User Manual

G R
etting eady for
CORD
CHANNEL
BUTTON
O
perating
Polarized Plug Notice
This product is equipped with a polarized alternating
current line plug (a plug having one blade wider than the
other). This plug will fit into the power outlet only one way.
This is a safety feature. If you are unable to insert the plug
fully into the outlet, try reversing the plug. If the plug
should still fail to fit, contact an electrician to replace the
obsolete outlet. Do not defeat the purpose of the polarized
plug.
Note:
Hose must be connected for unit to operate.
E N
U
se
Insert power nozzle plug
into the plug holder on
upper wand.
Pulling cord down, press
cord into cord channel on
bottom wand.
For convenience, do not
disassemble for storage.
Insert power handle into
upper wand until button
locks.
Pull plug from unit and
insert into wall outlet.
I
nstructions
Press the On/Off pedal
located at the rear of the
canister to turn on.
G L I S H
( ll )
BARE FLOOR
5
Turn handle switch to ( l )
position for unit only or ( ll )
position for unit and power
nozzle. The On/Off pedal
on canister must be On for
the handle switch to
( l )
operate.
Using the standard nozzle,
the nozzle is adjustable for
use on carpets (without
CARPET
brush) or hard floors (with
brush).
To adjust suction, use the
suction control slide on the
standard handle and
power handle.
To adjust power of motor,
use the slide control on top
of unit.
Upholstery tool, crevice
tool and dusting brush can
be found in storage
compartment.
Small accessories can be
used with telescopic wand
or handle alone.