Operating Instructions - Oreck DTX 1200A User Manual

TO ASSEMBLE POWER NOZZLE AND TELESCOPIC WAND
WITH CORD MANAGEMENT.
BUTTON
CORD
CHANNEL
BUTTON
E N
DTX 1200B G
etting
Connect hose by firmly
inserting end of hose into
canister intake opening
until it clicks.
To disconnect hose, turn
hose lock on canister
intake to unlock hose and
remove.
Insert telescopic wand into
power nozzle until button
locks. Once assembled, do
not disassemble.
Insert power nozzle plug
into plug holder on upper
end of wand.
Press cord into cord
channels.
For convenience, do not
disassemble for storage.
Insert power handle into
telescopic wand until
button locks.
G L I S H
R
eady for
O
perating
Polarized Plug Notice
This product is equipped with a polarized alternating
current line plug (a plug having one blade wider than the
other). This plug will fit into the power outlet only one way.
This is a safety feature. If you are unable to insert the plug
fully into the outlet, try reversing the plug. If the plug should
still fail to fit, contact an electrician to replace the obsolete
outlet. Do not defeat the purpose of the polarized plug.
6
U
se
To unlock the wand, step on
the release button located
on the power nozzle.
Gently lean wand back for
vacuum use.
Extend telescopic wand by
holding telescopic length
adjustment and pulling
power handle.
I
nstructions
Pull plug from unit and
insert into wall outlet.
Press the On/Off pedal
located at the rear of the
canister to turn on.
If using a power nozzle,
turn the power nozzle
On/Off by using the switch
located on the handle.