Mounting The Wire Rope; Adjustment Of Shooting Area And Focus - Sony SNC-VB770 Installation Manual

To remove the lens
1
Rotate the lens in the direction of the arrow until it
stops while pressing the Lens release button, then
remove.
Lens release button
2
Mount the body cap on the camera, and the cap on the
front and back of the lens.
• Mount the cap after removing dust.
Notes on lens exchange
If dust get into the camera and is stuck to the surface of the
image sensor (a part to convert the light to electrical
signals) upon the lens exchange, the dust may appear in the
image.
Mount/remove the lens at a location with little or no dust
in a quick manner.

Mounting the wire rope

Make sure to attach the supplied wire rope to prevent
falling accidents when you install the camera on the ceiling
or at substantial heights.
Attach the wire rope with supplied mounting screws
(illustrated in below) to the wire rope mounting screw
holes on the rear side of the camera.
Note
When you mount the wire rope, be careful when wiring to
prevent wire rope from short circuiting with a power
source terminal or cable.
Mounting screw (supplied)
1
Mount the wire rope to the junction box on the ceiling.
Use screws which fit the screw holes on the junction
box (not supplied).
2
Mount the wire rope with the supplied wire rope
mounting screws to the wire rope mounting screw
holes on the camera.
Warning
Use the supplied screws for mounting. Otherwise, the wire
rope may not function effectively.
Adjustment of shooting area and
focus
Determine the shooting area by adjusting the view angle
and focus while reviewing the image.
Adjust the view angle following the operating instructions
of the mounted lens.
Adjust the focus with SNC toolbox or SNC toolbox
mobile.
Adjustment by using SNC toolbox mobile
You can adjust the view angle easily by installing SNC
toolbox mobile on your smartphone or tablet.
If you insert IFU-WLM3 (sold separately), select the SSID
shown below under Wi-Fi settings on your smartphone.
SNC-[Mac address of IFU-WLM3]
Example:
Display with SSID with IFU-WLM3, when the Mac
address is 00-11-22-33-44-55:
SNC-001122334455
The default value of the password is shown below.
Password: T8qUDTUuFyb8a
Please refer to the SNC toolbox mobile application guide
on the Web site.
8
Wire rope (supplied)
Screw
(not supplied)