Power Off - iHome IB71 User Manual

To install the ear hooks thread the cable through he
slot on the ear hooks as shown and then push the ear
bud downward into the hook until it locks in place.
Refer to the following illustration.
To remove the ear-hooks, pull the ear buds upward to
release them from the hooks.
You may place the hooks over your ears first and then
position the ear buds in your ears, or you may place
the ear buds in your ears first and the position the
flexible hooks over your ears, whichever is easier for
you.
The iB71 ear buds have angled tips for a more secure
fit. They can only be worn one way, with the 'R' ear
bud in your right ear and the 'L' ear bud in your left ear.
The recommended usage is to position the cable
behind your neck before inserting the ear buds in your
ears. The ear buds should be worn with the control dongle on your right side.
Note: Noise isolation ear buds like the iB71 are designed to provide a good seal in your
ears and block outside sounds. You should not use noise isolation ear buds in
situations that require you to hear outside warning sounds
OPERATING INSTRUCTIONS
1. Switching Your Ear Buds On and Off
NOTE: The first time you perform this operation you might find it convenient to place
only the left ear bud in your left ear. This will allow you to hold the control dongle in
your right hand so that you can see the control buttons and the LED indicator and still
hear the confirming voice prompts in your left ear. Once the ear buds have turned on
and paired with your Bluetooth device you can then place the right ear bud in your
right ear.
2. Power On / Auto-Linking Mode
PRESS and HOLD the Multi-Function Button (MFB) on the control dongle for
approximately 2 seconds until you hear the "Power On" voice prompt that confirms
the power is 'On'. The blue LED begins flashing slowly indicating that your ear buds
are in the Auto-Linking Mode and trying to re-link to a previously paired device as long
as that device is within the normal pairing range of approximately 33-feet. If your ear
buds do not find a previously paired device that is in range and turned 'on' within 3
minutes they will switch from the Auto-Linking mode to the Power 'Off' mode to
extend the battery life.

3. Power Off

To shut the power 'Off' at any time PRESS and HOLD the Multi-Function Button (MFB)
on the control dongle for approximately 2 seconds. You will hear the voice prompt say
"Power Off". The red LED flashes three times and then the power shuts off.
2