Onix FH102A-S Quick Start Manual

Onix FH102A-S Quick Start Manual

Ceramic fan heater

Advertisement

1. Place heater on a flat surface ensuring there
is at least 30cm clearance all around and
over the top of the heater. Do Not place
items on or against the heater.
3. Turn the Thermostat control down
(anticlockwise) until you hear it click off.
5. With the Heat Selector Switch set to either "I"
or "II", turn the Thermostat control up slowly
(clockwise) until you hear it click On. The
heater will now start to heat. Adjust up or
down to your desired temperature setting.
Note: As the
thermostat
maintains room
temperature it
will switch on
and off.
As it switches
on and off, you may notice a blue flash from
inside the heater. This is NOT dangerous and
is no cause for alarm.
Quick Start Guide
Ceramic Fan Heater
2. Insert Plug into Power Point and switch on.
4. Rotate the Heat Selector switch to position:
for Fan Only
"I" for Low Heat
"II" for High Heat
"O" for OFF
6. Do not operate while unattended.
Turn the selector switch to position "O" (off)
then Turn power off and Unplug.
Always Unplug when not in use.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FH102A-S and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Onix FH102A-S

  • Page 1 Quick Start Guide Ceramic Fan Heater 1. Place heater on a flat surface ensuring there 2. Insert Plug into Power Point and switch on. is at least 30cm clearance all around and over the top of the heater. Do Not place items on or against the heater.
  • Page 2 Ceramic Fan Heater User Manual FH102A-S 220 - 240Va.c. 50Hz 1500W Rev 1 Note: The specifications and/or components of this appliance are subject to change without prior notice. Page 2 of 12...
  • Page 3: Table Of Contents

    Important Safeguards ............4 Component Diagram .............6 Before Use ................7 Tip Over Switch ..............7 Operation ................8 Controls ..................... 8 Safety Cut-Off Device ............9 Cleaning ................9 Schematic Wiring Diagram ..........10 When the Appliance is Not in Use ........10 10 Troubleshooting ..............11 11 Warranty Against Defect ............
  • Page 4: Important Safeguards

    Important Safeguards When using electrical appliances, basic safety precautions should always be followed, including the following: • Carefully read this instruction manual before using appliance. • Keep appliance out of reach of young children. • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
  • Page 5 • Use only accessories recommended or supplied by an authorised service centre or qualified dealer. The use of accessories not intended for use with this appliance may cause injuries to the user or damage to the appliance. • Always unplug the heater when not in use •...
  • Page 6: Component Diagram

    Component Diagram Item Description Carry Handle at Rear Fan / Heat Control Switch Hot Air Outlet Grille Tip Over Switch under base Power Indicator Light Adjustable Room Thermostat NOTE: Never Leave the Heater unattended when in use. Page 6 of 12...
  • Page 7: Before Use

    Before Use Remove all packaging and dispose of thoughtfully. Congratulations on the purchase of your new heater. Before first using your new heater, it is most important that you read and follow the instructions in this instruction manual, even if you feel you are quite familiar with this type of product.
  • Page 8: Operation

    Operation Controls • Ensure the Fan control is set to the “O” (Off) position. • Fully unwind the power cord then plug into the powerpoint and switch on. • When first setting up the temperature setting, turn the Fan / On-Off / Heat Control Switch to Maximum Power “II”...
  • Page 9: Safety Cut-Off Device

    CAUTION: Even after the heater has been turned off, the heater will remain very hot for some time after. DO NOT touch the hot surfaces during heating or after turned off. • If you wish to just recirculate the room air without heating, turn the Fan / On-Off / Heat ...
  • Page 10: Schematic Wiring Diagram

    Schematic Wiring Diagram When the Appliance is Not in Use When the appliance is not in use or is not going to be used for a long period, disconnect from the electricity supply and store in a dry safe place. Page 10 of 12...
  • Page 11: Troubleshooting

    10 Troubleshooting BEFORE contacting a service agent, check the following points: Symptom Cause Remedy The Power Plug may not be Ensure the power plug is inserted plugged in to the power point and into the powerpoint correctly and switched on. switch on.
  • Page 12: Warranty Against Defect

    11 Warranty Against Defect WHAT’S COVERED? 5.2 Our goods come with guarantees that cannot be excluded under Australian Consumer Law. You H.E. Group Pty Ltd (“us” “we” or “our”) are entitled to a replacement or refund for a warrants this good for a full replacement or major failure and compensation for any other refund for a period of twelve months from reasonably foreseeable loss or damage.

Table of Contents

Save PDF