Amplicomms NL 200 Operating Instructions Manual page 15

1. Press and hold the Power button (4) on
the NL200 until the Status LED (3) lights
up blue.
2. A short time later, the Status LED (3)
flashes blue and the NL200 is registered
on the mobile phone.
Switching the NL200 off
1. Press and hold the Power button (4) on
the NL200 until the Status LED (3) no
longer lights up.
Increasing the volume
1. During a call, press and hold the Volume
Up button (5) until the required volume is
set.
2. An acoustic alert signal is issued on
reaching the maximum volume.
Reducing the volume
1. During a call, press and hold the Volume
Down button (6) until the required
volume is set.
2. An acoustic alert signal is issued on
reaching the minimum volume.
0844 800 6503 (Using an UK landline, at the time of going to print: calls cost 6p for connection charge
Cancelling the dialling process / Ending a call
Taking a call
Voice command
and then 5p a minute. Mobile costs may vary.
1. Press the Power button (4) briefly to
cancel the dialling process and/or end
the call.
1. Press the Power button (4) briefly to
take a call.
You can control the voice command functions
of the mobile phone via the NL200. A condi-
tion for this is that your mobile phone sup-
ports the functions. For more information,
refer to the operating manual provided with
your mobile phone.
1. If the NL200 is in Standby mode, press
Power button (4) briefly.
2. The mobile phone now receives the
voice commands via the microphone in
the NL200.
Using the NL200
15