Setting At Work - GGP ITALY 132508000 Instruction

Attaching the Pruner
1
1) Remove the top ring nut.
2) Attach the head of the brush cutter to the pruner, fitting the spindle into the specific seat.
3) Fit the bracket, clamp the screw, close until the fixing flange is parallel to the head.
Caution:
If it is difficult to fit the sleeve over the shaft, remove the head of the brush cutter and fit it on the sleeve of
the pruner rotating the gears of the head shaft.

Setting at work

– Fill the oil tank and tighten the cap. Check the
level with each refill. Use suitable oils. Contact
your local dealer.
– When starting the motor make sure the chain is
NOT resting on the ground and does not come
into contact with foreign bodies; for this purpose,
position the rod appropriately.
– Follow the instructions supplied with the brush
cutter to start the motor.
– Prune by making a first cut from below on the part
to be cut, then cut from above, to avoid barking
2
and damage to the plant.
– For cutting diameters of above 100 mm multiple
cuts are preferable.
– When pruning operate outside the area in which
cut material falls.
– Never bring the cutting blades close to body parts
while working.
– Always fit the bar guard when the device is swit-
ched off.
3
GB
23