Kenwood DDX9716BTS Instruction Manual page 73

CONNECTION/INSTALLATION
❏ Connecting microphone for Bluetooth
Connect the microphone (7) to the MIC terminal.
• To install the microphone, peel off the adhesive
tape, fix it on the installation position, then adjust
the direction of the microphone to face the driver.
After installing, fix the microphone cable to the car
with clamps (commercially available).
– Clean the installation surface beforehand.
❏ Connecting the GPS antenna
Connect the GPS antenna (5) to the GPS terminal.
• To install the GPS antenna, fix the metal plate
(6) firmly on the dashboard, then place the GPS
antenna (5) on the metal plate (6).
– Clean the dashboard or other surface
beforehand.
– Install the GPS antenna (5) inside of the car, as
horizontally as possible to allow easy reception
of the GPS satellite signals.
– You can bend the metal plate (6) to conform to
a curved surface, if necessary.
5
7
6
5
• Depending on the type of car, reception of the
GPS satellite signals might not be possible with an
internal installation.
• Install this GPS antenna in an area away from any
antennas that are used with CB radios or satellite
televisions.
• The GPS antenna should be installed at a position
at least 30 cm from mobile phone or other
transmitting antennas.
• The above types of communication may interfere
with signals from the GPS satellite.
• Painting the GPS antenna with (metallic) paint
may cause reduced performance.
ENGLISH 73