Becker Traffic Assist Z099 Installation Manual page 13

Installation manual
Subsequent synchronisations are much quicker . Once the synchronisation process is
complete, the message "Last synchronisation successful" will be displayed in the status
line in the lower section of the navigation system's screen . After downloading all of your
desired POIs and Insider Tips, simply close the menu . You may notice short delays when
navigating the main menu following the first synchronisation .
Should you no longer need them, you can remove all POIs installed by the POI FINDER
Sync-Tool by pressing the "Delete POIs from device" button .
Note: The additional POIs and Insider Tips which you have installed using the Sync-Tool
can be retrieved on your Becker navigation system by clicking "Select Destination -> Enter
destination -> Select Point of Interest -> POI nearby -> POI FINDER" .
In order to be alerted by sound of possible danger spots, you must activate sound
warnings by following "Settings -> Navigation settings -> Danger spots" . However, this
can only be done with an active GPS signal .
Synchronising POIs
Fig . 9: POIs shown on the map
1