Table of Contents
Advertisement
The 3 second level
The 10-second level
Display symbols
Outdoor compensation
configured
Cascade control
Temperature control
Rasdiator circuit control
Domestic hot water control
Fan run indicator
Setpoint
When in the Base Display, a press on the encoder button gives direct access to the Setpoint
menu. See chapter 7 Setpoint.
If there are any active alarms, a press on the encoder button will instead give access to the
alarm handling menus. Here the alarms are displayed and can be acknowledged. There is one
menu display for each alarm with symbols showing which type of alarm it is. See chapter 8
Alarm handling.
This level is reached from the Base display by pressing and holding the encoder button for 3
seconds. The 3-second level holds all menus for setting the clock and the scheduler program.
See chapter 9 Clock and Scheduler.
This level is reached from the Base Display by depressing and holding the encoder button for
10 seconds. The 10-second level holds all the configuration menus. See chapter 10
Configuration.
Alarm indicator
Active 0...10V
input signal
Configuration level
Menu holds
AO2 Graphic output signal
changable values
Control mode 1 only
or 3-position output
indicator
Menu number
AO1 Graphic output signal
Control mode 1 only
Bargraph AO1 output level
Bargraph AO2 output level
21
Advertisement
Table of Contents
