Cleaning The Inside; Cleaning The Outside - Kenmore 253.12502 Use & Care Manual

Care & Cleaning
Defrost
Drain Plug
Defrost
Drain
Plug
• Remove the drain plug inside the freezer
by turning counterclockwise (see figure 3).
Defrost water will drain out. Check pan
occasionally so water does not overflow.
Drain
Plug
• Replace the drain plugs when defrosting
and cleaning are completed. If the drain is
left open, warm air may enter the freezer.
Pan
Figure 1
Hose
Adaptor
Figure 2
Figure 3
To Defrost Models without Defrost Drain:
• Place towels on the freezer bottom to catch
the frost. The frost will loosen and fall.
• Remove the towels.
• If the frost is soft, remove it by using a
plastic scraper. If the frost is glazed and
hard, fill deep pans with hot water and
place them on the freezer bottom.
• Close the freezer lid. Frost should soften in
about fifteen (15) minutes.
• Repeat this procedure if necessary.

Cleaning the Inside

After defrosting, wash inside surfaces of the
freezer with a solution of two tablespoons
of baking soda in one quart (1.1 liters) warm
water. Rinse and dry. Wring excess water out
of the sponge or cloth when cleaning in the
area of the controls, or any electrical parts.
Wash the removable parts and baskets
with the baking soda solution mentioned
above, or mild detergent and warm water.
Rinse and dry. Never use metallic scouring
pads, brushes, abrasive cleaners, or alkaline
solutions on any surface. Do not wash
removable parts in a dishwasher.
NOTE
If unit is turned off or unplugged for several
hours, do not open freezer lid unnecessarily
to assure the coldest temperature inside
is maintained and that recovery time to
desired temperature is minimal.

Cleaning the Outside

Wash the cabinet with warm water and mild
liquid detergent. Rinse well and wipe dry
with a clean soft cloth.
10