Table of Contents
Advertisement
10. PROTECTOR OPERATION CHECKING
No.
Adjustment point
1
BEAM
PROTECTOR
2
H, V PROTECTOR
3
OTHER
PROTECTOR
11. A/V INPUT, OUTPUT & COMPONENT IN CHECKING
No.
Adjustment point
1
VIDEO AND
AUDIO OUTPUT
CHECK
2
VIDEO AND
AUDIO INPUT
CHECK
3
COMPONENT IN
CHECK
Adjustment procedure/conditions
1) Receive "Monoscope Pattern" signal.
2) Set CONTRAST MAX.
3) Set BRIGHT MAX.
4) During the Collector & Emitter of Q853/4/5 short,
make sure the protector ON and switch to standby
mode.
1) Receive "Monoscope Pattern" signal.
2) Connect output of Bias Box to D602 cathode
(C602 positive).
3) Set voltage of Bias Box to 18V and make sure
the protector is not working.
4) Set voltage of Bias Box to 27V , and make sure
the protector is working.
1) Once finish rectified Electrolytic Capacitor short
testing in +B line, check all possible damaged
components on +B line.
(Use random selected set for inspection)
Adjustment procedure/conditions
1) Receive the "PAL Color Bar" signal (100%
White Color Bar, Sound 400 Hz 100% Mod).
2) Terminate the Video output with a 75 ohm
impedance.
Make sure the output is as specified
(1.0 Vp-p ± 3 dB).
3) Terminate the Audio output with a 10K ohm
impedance.
Make sure the O/P is as specified
(1.5 Vp-p ± 3 dB).
1) Using the TV/VIDEO key on the remote control-
ler, make sure that the modes change in order of
TV, AV1, AV2 & TV again and the video & audio
output are according to the input terminal for
each mode.
1) Connect YUV & Audio signal to Component In
terminal and Audio terminal.
2) Using the TV/VIDEO key on the remote
controler, press it until the modes change to
COMPONENT, confirm output is appear.
3 – 22
21J-FG1RU
Waveform and others
* Select one of Q853/4/5 to do
each short.
Waveform and others
Advertisement
Table of Contents
