Browser & Lcd Display - Pioneer XDJ-R1 Operation Manual

9. TRIM: Adjusts the audio level (gain) of the corresponding channel in the software or
hardware Input
10. HEADPHONES MIXING: Turn to mix between Cue and Program in the Headphone
channel. When all the way to the left, only channels selected by the CUE/PFL
buttons (4) will be heard. When all the way to the right, only the Program mix will be
heard.
11. HEADPHONES VOLUME: Controls the level of the Headphones Output Channel..
12. SOUND COLOR FX: Use these buttons to enable/disable a Sound Color FX (its LED
will blink when enabled) and then use the COLOR knob (6) to adjust its applied level
on the left or right deck.
In MIDI mode, only the PITCH and FILTER Color FX are available.
13. MASTER VOLUME: Adjust the level of the Master Output.
14. BOOTH VOLUME: Adjust the level of the Booth Output.
15. AUX LVL & ON/OFF: Adjust the Output Level of the Auxililary Input. Use the
ON/OFF button to route/block the signal of the Auxiliary Input to the Master Output.
16. MIC LEVEL/EQ & ON/OFF: Adjust the Output Level of the Microphone Input. Use
the ON/OFF button to route/block the signal of the Microphone Input to the Master
Output. Use the MIC EQ to adjust the Tone of the Microphone Input.
B. Browser & LCD Display
The LCD screens are not offering any Track or software information in MIDI mode (firmware
limitation). When the left/right side is set to MIDI mode, the LCD screen will display "MIDI
CONTROL" and the assigned deck (e.g. DECK A).
17. TIME: Use this button to toggle the Left and Right assigned decks. The Left side of
the XDJ-R1 will toggle between Decks 1 and 3 (A and C) and the right side will toggle
between decks 3 and 4 (B and D). The assigned deck will be displayed at the LCD
screen each time.
VirtualDJ 8 – Pioneer XDJ-R1
7