Download Print this page

Makita BDF460 Instruction Manual page 6

Cordless driver drill equipped with electric brake
Hide thumbs Also See for BDF460:

Advertisement

uscoo2-1
Length of Cord (Feet)
AWG Size
of
Cord
IMPORTANT SAFETY INSTRUCTIONS
2 5
50
100
150
18
18
18
16
FOR CHARGER &
BATTERY CARTRIDGE
I.
SAVE THESE INSTRUCTIONS
-
This manual
contains important safety and operating instructions for battery charger.
2. Before using battery charger, read all instructions and cautionary markings
on
(I)
battery charger,
(2)
battery, and
(3)
product using battery.
3.
CAUTION - To reduce risk of injury, charge only MAKITA rechargeable
batteries marked on the charger label. Other types of batteries may burst
causing personal injury and damage.
4. Do not expose charger t o rain or snow.
5. Use of an attachment not recommended or sold by the battery charger
manufacturer may result in a risk of fire, electric shock, or injury t o persons.
6. To
reduce risk of damage t o electric plug and cord, pull by plug rather than
cord when disconnecting charger.
7.
Make sure cord is located
so
that it
will
not be stepped on, tripped over, or
otherwise subjected t o damage or stress.
8.
A n extension cord should n o t be used unless absolutely necessary. Use of
improper extension cord could result
in
a risk of fire and electric shock.
If
extension cord must be used, make sure:
a. That pins on plug of extension cord are the same number, size. and shape
b. That extension cord is properly wired and in good electrical condition; and
c. That wire size is at least as large as the one specified in the table below.
TABLE
1
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS FOR BATTERY CHARGERS
as those of plug on charger;
9.
Do n o t operate charger with damaged cord or plug
-
replace them im-
mediately.
IO.
Do not operate charger if it has received a sharp blow, been dropped, or other-
wise damaged in any way; take it t o a qualified serviceman.
1 1 .
Do not disassemble charger or battery cartridge; take it t o a qualified
serviceman when service or repair i s required. Incorrect reassembly may
result in a risk of electric shock or fire.
12.
To reduce risk of electric shock, unplug charger from outlet before attempt-
ing any maintenance or cleaning. Turning off controls
will
not reduce this risk.
6

Advertisement

loading