Assembly Instructions - Health O Meter PROPLUS 2101 SERIES User Instructions

ASSEMBLY INSTRUCTIONS (CONTINUED)
Assembling a 2101 Series Scale (continued):
13. Rotate the display support 90˚ then position the Display Assembly close to the Display Support. Plug the
load cell cable connector into the load cell port on the rear of the Display then insert and secure the cable
into the center channel in the display. See Figure 2, above, for an illustration. Note: Do not attach the
power cord at this point. Wait until Step 19.
14. Slide the display assembly onto the metal display support insuring that the two metal tabs go into the two
slots in the rear of the display. Note: The load cell cable should now be secured in the channel
between the display assembly and the display support.
15. Insert four (4) Phillips pan head M4 screws (E) into the metal display support, and tighten (see Figure 1).
16. Attach the Adapter Holder to the center rail using two (2) #8 x ½ (D) sheet metal screws, and tighten.
17. Connect the power adapter to the power port in the display, then insert and secure the cable into the exposed
portion of the second channel from the left in the back of the display (see Figure 2, above). Hold the cord in
place through the retaining slot on the rear cover and align the large rear cover tabs with the slots on the rear
of the display assembly. Apply light pressure to snap the cover into place and secure it with two (2) Phillips
pan head M4 screws (E). Do not plug the scale into a power source until the scale is fully assembled.
18. Rotate the display to align it with the center handrail then attach the front and small rear display support
covers, applying light pressure to snap these covers into place.
19. Secure the power cord to the inside of the center handrail, using the 4 plastic cable clips, arranged to hold
the cord out of the way. The adhesive backing on the clips will peel off then the clips can be fastened to the
scale by applying light pressure.
20. The scale is now assembled. Plug the scale adapter into a power source and / or insert batteries.
SET UP
ProPlus® 2101Series scales are shipped with the Menu Lock function enabled. The Menu Lock function
disables certain buttons on the scale's keypad, preventing unauthorized users from making changes to
your scale settings. The Menu Lock can be bypassed temporarily to allow you to customize your scale
with the functionality you prefer. Please refer to the ProPlus® Display Module User Manual for
instructions on how to bypass the Menu Lock.
Preparing the Scale for Use
1. Remove protective plastic films covering the keypad and display.
2. Place batteries in the battery holder (see "Batteries" information in Figure 3, below).
3. Plug the scale's power adapter into the power source.
4. Be sure all objects are removed from the scale's platform, and then press the ON/OFF button to turn the
scale on. The display will show "Health o meter ProPlus" and then "000Lb00oz" or "0.0KG". Note: To adjust
the display backlight and/or contrast, please refer to the ProPlus® Display Module User Manual.
5. Press the KG/LB button to select the weight mode (pounds or kilos). To change the display mode in pounds
to fractions or decimals, please refer to the ProPlus® Display Module User Manual.
Note: The scale will always default to the settings and units last used (LB or KG).
6. When you disconnect the scale's power adapter from the power source, the scale will switch to battery
power, if batteries are installed. Note: If the set up procedure failed, refer to the troubleshooting instructions.
If the problem is not corrected, refer to qualified service personnel.
Figure 2