Install The High-Low Station Cable - ivanko IVK 5500 Owner's Manual

STEP 14 Install the High-Low Station Cable (See Diagram 14)
A.) Insert the tip of the 262" High-Low Cable (#53) in between the pre-assembled two
Small Pulleys (#85) on the Sliding Pulley Frame (#22). Note: You might need to
remove one of the Pulleys in able to see the hole.
B.) Draw the Cable through the Sliding Pulley Frame then pull upward to the Pulley on
the top opening of the Sliding Pulley Vertical Beam (#9).
C.) Draw the Cable over the Pulley then pull forward to the Pulley on the rear opening on
the Upper Frame (#5).
D.) Draw the Cable over the Pulley then pull downward. Attach the Cable to the Pulley
on the Single Floating Pulley Bracket (#23) installed in Step12.
E.) Draw the Cable underneath the Pulley then pull upward to the Pulley on the upper
Rear Vertical Frame (#4). Let the Single Floating Pulley Bracket (#23) hanging for
now.
F.) Draw the Cable around the Pulley then drop the Cable inside the tube downward
through the Rear Vertical Frame to the Pulley on the bottom opening. Remove the
Pulley to get the Cable out then reinstall the Pulley. Draw the Cable underneath the
Pulley then pull upward to the bracket on the Sliding Pulley Frame (#21).
G.) Attach the Cable ball tip to the bracket. Secure the bracket with one M10 x 1 1/8"
Allen Bolt (#99) and M10 Aircraft Nut (#125).
H.) Connect the Single Handle (#35) to the end of the Cable with a Hook (#41).
22