Makita UC3020A Instruction Manual page 18

1
1. Push nut
2. Slotted bit screwdriver
1
1. Filter
1
1. Filter
18
Cleaning the oil filter at the oil discharge hole
Small dust or particles may be built up in the oil filter at the oil discharge hole
during operation.
Small dust or particles built up in the oil filter may impair the oil discharge flow
and cause an insufficient lubrication on the whole saw chain.
When a poor chain oil delivery occurs at the top of guide bar, clean the filter as
follows.
Unplug the tool from the mains.
Remove the sprocket cover and saw chain from the tool. (Refer to the section
titled " Installing or removing saw chain ".)
Remove the push nut using a slotted bit screwdriver with a slender shaft or the
007057
like.
2
Take the filter out of the chain saw and remove small dust or particles from it.
007058
When the filter is too dirty, replace it with a new one.
Plug in the tool.
Pull the switch trigger to flow built-up dust or particles off the oil discharge hole
007059
by discharging chain oil.
Unplug the tool from the mains.
Insert the cleaned oil filter into the oil discharge hole. When the filter is too
007060
dirty, replace it with a new one.