Electrical Connection - Beem Samowar 3000 Instruction Manual

Select the installation location such that children cannot come
■
into contact with hot surfaces of the appliance.
Do not install the appliance under a wall cabinet.
■
The plug socket must be easily accessible so that the mains
■
plug can be easily pulled out in an emergency.

Electrical connection

For safe and trouble-free operation of the appliance, the following
instructions must be observed for the electrical connection:
Before connecting the appliance, check the connection data
■
(voltage and frequency) on the rating plate with those of your
mains power supply. This data must correspond in order to
avoid damage to the appliance. If in doubt, ask a qualified
electrician.
The plug socket must be protected by at least a 10 A circuit
■
breaker.
Ensure that the connecting lead is undamaged and is not laid
■
over hot surfaces or sharp edges.
The connecting lead must not be strained or come into contact
■
with the hot appliance.
Lay the connecting lead in such a way that it does not pose a
■
tripping hazard.
The appliance may only be connected to a multiple plug
■
socket with a cable cross-section of 1.5 mm².
The
■
it is connected to a properly installed protective earth (PE)
conductor system. Connection to a plug socket without PE
conductor is forbidden. If in doubt, have the house installation
checked by a qualified electrician.
The manufacturer assumes no liability for injury or damage
caused by a missing or interrupted protective earth conductor.
BEEM - Elements of Lifestyle
electrical safety of the appliance is only assured when
Setting up and connection
EN
47