Table of Contents
Advertisement
General Information continued-
Install a discharge line so that water discharged from the
temperature and pressure relief valve will exit within six (6) inches
above, or any distance below, the structural floor and cannot
contact any live electrical part. The discharge line is to be installed
to allow for complete drainage of both the temperature and pressure
relief valve and the discharge line. The discharge opening must not
be subjected to blockage or freezing. DO NOT thread, plug, or cap
the discharge line. It is recommended that a minimum clearance of
four (4) inches be provided on the side of the water heater for
servicing and maintenance of the combination temperature and
pressure relief valve.
Do not place a valve between the combination temperature and
pressure relief valve and the tank!
A sacrificial anode is used to extend tank life. The removal of this
anode, except for inspection and/or replacement, will nullify the
warranty. In areas where water is unusually active, an odor may occur at
the hot water faucet due to a reaction between the sacrificial anode and
the impurities in the water. If this should happen, an alternative anode
may be purchased from the supplier that installed this water heater. This
will minimize the odor while protecting the tank. Additionally, the
water heater should be flushed with appropriate dissolvers to eliminate
any bacteria.
This product contains one or more chemicals known to the State of
California to cause cancer, birth defects, or reproductive harm.
WARNING
WARNING
14
Advertisement
Table of Contents
