Sound Pressure; Sound Power; Safety And Instructional Decals - Toro CCR Powerlite 38173 Operator's Manual

•
If a shield, safety device, or decal is damaged, illegible,
or lost, repair or replace it before beginning operation.
Also, tighten any loose fasteners.
•
Do not smoke while handling gasoline.
•
Do not use the snowthrower on a roof.
•
Do not touch the engine while it is running or soon
after it has stopped because the engine may be hot
enough to cause a burn.
•
Perform only those maintenance instructions described
in this manual. Before performing any maintenance,
service, or adjustment, stop the engine, remove the key,
and disconnect the wire from the spark plug. If major
repairs are ever needed, contact an Authorized Service
Dealer.
•
Do not change the governor settings on the engine.
•
When storing the snowthrower for more than 30 days,
drain the fuel from the fuel tank to prevent a potential
hazard. Store fuel in an approved fuel container.

Safety and Instructional Decals

Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals.
94-2560
1. Cutting/dismemberment hazard, impeller—stay away from
moving parts; remove the key and read the instructions before
servicing or performing maintenance.
94-2561
1. Hot surface/burn hazard—keep bystanders a safe distance from
the machine.
Remove the key from the ignition switch before storing
the snowthrower.
•
Purchase only genuine Toro replacement parts and
accessories.

Sound Pressure

This unit has a maximum sound pressure level at the
operator's ear of 90 dBA, based on measurements of
identical machines per EN 11201.

Sound Power

This unit has a guaranteed sound power level of 107 dBA,
based on measurements of identical machines per EN 3744.
Vibration
This unit does not exceed a hand/arm vibration level of
11.4 m/s 2 , based on measurements of identical machines
per EN 1033.
1. Cutting/dismemberment hazard, auger—stay away from moving
parts; remove the key and read the instructions before servicing
or performing maintenance.
1. To engage the auger, hold the control bar against the handle.
2. To disengage the auger, release the control bar.
3
94-2562
94-2577