Panasonic DMC-FZ30PP Operating Instructions Manual page 120

• If the remaining battery power is
• If the remaining battery power becomes
• While [ACCESS] is being displayed, do
• When the OS of your PC is Windows
• Do not use any other USB connection
• Also refer to the operating instructions of
∫ PictBridge (PTP) setting
Even if you set the [USB MODE] to
[PictBridge (PTP)], you can connect to the
PC only when the OS is Windows XP
Home Edition, Windows XP Professional or
Mac OS X.
• You can only load pictures from the
• When there are 1000 or more pictures on
120
VQT0R81
Downloaded From camera-usermanual.com Panasonic Manuals
exhausted during communication, the
recorded data may be damaged. When
you connect the camera to the PC, use a
battery with sufficient battery power (P13)
or the AC adaptor (DMW-CAC1; optional).
low during communication, the power
indicator blinks (P13) and the alarm
beeps. In this case, stop the
communication at once.
not disconnect the USB connection cable.
2000 and you connect the camera to
the PC with the USB connection cable,
do not replace the card with the
camera connected to the PC. The
information in the card may be
damaged. Make sure to disconnect the
USB connection cable beforehand
when you replace the card. For details,
refer to the separate operating
instructions for PC connection.
cables except the supplied one.
the PC.
camera and cannot write them on the card
or delete them.
a card, the pictures may not be imported.
Connecting to a PC or Printer