Folding The Handle - Toro Super Recycler 20381 Operator's Manual

WARNING
The machine may dislodge material from under the
machine.
• Wear eye protection.
• Stay in the operating position (behind the
handle) when the engine is running.
• Do not allow bystanders in the area.
For best results, clean the machine soon after you have
completed mowing.
1. Move the machine onto a flat paved surface.
2. Stop the engine and wait for all moving parts to stop
before leaving the operating position.
3. Lower the machine to its lowest cutting-height setting.
Refer to Adjusting the Cutting Height (page
4. Attach a garden hose that is connected to a water
supply to the washout port on the machine
Figure 33
1. Washout port
5. Turn the water on.
6. Start the engine and run it until there are no more
clippings that come out from under the machine.
7. Stop the engine.
8. Shut off the water and disconnect the garden hose
from the machine.
9. Start the engine and run it for a few minutes to dry the
underside of the machine.
11).
(Figure
1
G017477

Folding the Handle

WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the electric-start button
33).
1. Electric starter
2. Rotate the handle forward
Important: Route the cables to the outside of the
handle knobs as you fold the upper handle.
17
(Figure 34).
Figure 34
2. Electric-start button
(Figure 35).