Overview Of The Components - Clatronic HSM 2685 Instruction Manual & Guarantee

Hide thumbs Also See for HSM 2685:

Instruction manual (43 pages)

Table Of Contents

Table of Contents

Available languages

•

Only dry hair should be cut with this machine.

•

Only use the machine for cutting hair.

•

Do not use the device near water (e.g. bathtubs, sinks or other containers filled with

water).

1 Adjustment of the cutting length

2 On/off switch

3 Lower blade

4 Upper blade

5 Blade rail

6 Voltage adjustment

Fine Adjustment of the Voltage (Mains operated Machines)

In case of voltage fluctuations in the mains it may be necessary to adjust the

machine. Switch the machine on. Turn the voltage adjustment screw (6) with a screwdriver

or small coin so that the machine runs as quietly as possible.

Preparing for Cutting

1. Briefly comb the hair.

2. Remove the blade protection.

3. Oil the blades slightly.

4. Place a cutting length guide suitable to the desired cutting length. If you are not sure of

the cutting length, start from 12 mm. Insert the blades in the slot and fit the attachment

on the blade.

5. Insert the plug in a duly installed 230 V/50 Hz protective contact socket, switch on the de-

vice and run the device with the guide comb upwards and at a constant speed through

your hair. The guide is held in a level position.

Cutting without Cutting Length Accessory

This is suitable for trimming the hair. The cutting length can be adjusted continuously in the

range of approximately 0 - 2 mm.

For areas which are not accessible to the razor it is possible to use a pair of scissors.

Important: Do not use the device for more than 10 minutes. Allow the equipment to cool

down for 10 minutes, before using it again.

05-HSM 2685

Special Safety Advice for this Machine