Display And Debug Gvrp; Gvrp Configuration Example - Quidway S5000 series Operation Manual

Operation Manual - VLAN
Quidway S5000 Series Ethernet Switches
When one Trunk port is set as fixed, the system will add the port to the VLAN if a
static VLAN is created on the switch and the Trunk port allows the VLAN passing.
GVRP will also add this VLAN item to the local GVRP database, one link table for
GVRP maintenance. However, GVRP cannot learn dynamic VLAN through this
port. The learned dynamic VLAN from other ports of the local switch will not be
able to send statements to outside through this port.
When an Ethernet port is set to be in Forbidden registration mode, all the VLANs
except VLAN1 will be logged out and no other VLANs can be created and
registered on this port.
Perform the following configurations in Ethernet port view.
Table 2-5 Set GVRP registration type
Set GVRP registration type
Restore the default GVRP registration type
By default, GVRP registration type is normal.

2.2.5 Display and Debug GVRP

After the above configuration, execute display command in any view to display the
running of GVRP configuration, and to verify the effect of the configuration. Execute
debugging command in user view to debug the configuration of GVRP.
Table 2-6 Display and debug GVRP
Display GVRP statistics information
Display GVRP global status information
Enable GVRP packet or event debugging
Disable GVRP packet or event debugging

2.2.6 GVRP Configuration Example

I. Networking requirements
To dynamically register and update VLAN information among switches, GVRP needs to
be enabled on the switches.
Operation
Operation
2-5
Chapter 2 GARP/GVRP Configuration
gvrp registration { normal | fixed | forbidden }
undo gvrp registration
Command
display gvrp statistics [ interface interface-list ]
display gvrp status
debugging gvrp { packet | event}
undo debugging gvrp { packet | event }
Command