Electrical System Maintenance; Replacing The Fuse; Servicing The Headlights - Toro 74593 Operator's Manual

Electrical System
Maintenance

Replacing the Fuse

The electrical system is protected by fuses. They are
located beneath the hood, near the fuel tank (Figure 30).
If a fuse goes out, check the circuit wiring for a short.
Figure 30
1. Main/battery
2. Interlock, electric clutch,
and cruise control
To replace a fuse, pull up to remove it from the socket.
Push down to insert it.
• Main/ Battery—15 amp
• Interlock, electric clutch, and cruise control—10
amp
• Full bag buzzer—5 amp

Servicing the Headlights

Removing the Bulb
1. Disengage the blades (PTO).
2. Set the parking brake.
3. Stop the engine and wait for all moving parts to stop.
4. Remove the ignition key.
5. Open the hood.
6. Disconnect the wire connectors from both of the
bulb holder terminals.
7. Rotate the bulb holder 1/4 turn counterclockwise
and remove it from the reflector (Figure 31).
3. Full bag buzzer
4. Extra fuse
1. Bulb holder
2. Reflector
3. Tab (2)
8. Push and rotate the bulb counterclockwise about
1/4 turn until it stops and remove the bulb from the
bulb holder (Figure 32).
1. Bulb
2. Metal pins
Installing the Bulb
1. Align the metal pins on the base of the bulb with the
slots in the bulb holder and insert the base into the
holder (Figure 32).
2. Push and rotate the bulb clockwise until it stops.
3. Align the tabs on the bulb holder (Figure 32) with
the slots in the reflector.
4. Insert the bulb holder into the reflector and rotate it
1/4 turn clockwise until it stops.
5. Connect the wire connectors to the terminals on the
bulb holder.
27
Figure 31
4. Slots
5. Terminals
Figure 32
3. Bulb holder
4. Slots