Advertisement
Greasing the Rack
It is important to grease the Rack every 5 hours for proper operation.
Tools and Supplies needed:
General Purpose Lithium Grease
Clean Rags
1. Pull out the Ram and slide both return Spring ends from the Ram Bearing
hardware (Figure 27).
2. Pull the Rack out and grease the Teeth (Figure 28).
3. Reinstall the Spring ends when finished greasing.
Changing and Adjusting the Belt
Tools and Supplies needed:
Two 9/16" Wrenches
V Belt: 4L750
1. Remove the long Flange Bolt and Locknut that secures the lower portion of
the Guards to the Frame using two 9/16" Wrenches (Figure 29).
2. Remove the five short Flange Bolts and Locknuts that secure the Guard
Flanges together using two 9/16" Wrenches and remove the left side Guard
from the Splitter.
3. Loosen the front two Engine Mount Pivot Bolts and Locknuts with two 9/16"
Wrenches (Figure 30).
4. Loosen the rear two Angle Setting Bolts with Flat Washers using two 9/16"
Wrench.
5. Pivot the Mount up slightly and remove the Belt (Figure 31).
Flywheel
Pulley
Figure 31
Belt
Spring
Figure 27
Rack
Teeth
Figure 28
Safety Interlock Lever
Left Side Guard
Short
Flange
Bolts
Figure 29
Loosen
Belt
Tighten
Angle
Belt
Setting
Bolts
Figure 30
CONTACT US AT 1-888-545-6576
Ram
Bearing
Short
Flange
Bolts
Long
Flange
Bolt
Engine
Mount
Pivot Bolts
17
Advertisement
