Figure 34
1. Oil dipstick
2. Metal end
Changing the Engine Oil
Service Interval: After the first 50 hours
Every 100 hours
1. Start the engine and let it run for five minutes. This
warms the oil so it drains better.
2. Park the machine on a level surface.
3. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
4. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
5. Place a pan below the oil drain. Remove the drain
plug and let the oil drain completely (Figure 35).
6. Remove the oil filler cap from the top of the engine
(Figure 37). This will help the oil to drain.
7. Install the drain plug and tighten it to 25-1/2 ft-lb
(35 N•m).
Note: Dispose of the used oil at a recycling center.
3. Rear left side of machine
1. Back of machine
Adding Engine Oil
1. Tilt the seat forward and remove the front engine
panel (Figure 36).
1. Knob
2. Remove the oil filler cap and the dipstick (Figure 37).
33
Figure 35
2. Drain plug
Figure 36
2. Front engine panel