Selecting Ground Speeds; Stopping The Machine - Toro 71226 Operator's Manual

Selecting Ground Speeds

IMPORTANT: To avoid transmission
damage, always depress the clutch/brake
pedal before shifting into or out of reverse.
Always start the machine in motion by depressing the
clutch/brake pedal and shifting into the desired speed.
Once the machine is in motion, you can shift into any
forward speed without depressing the clutch/brake
pedal. In most conditions, the machine is powerful
enough to move out in any speed. If it will not move
out in a selected speed (i.e., #5) due to a heavy load,
use a lower speed (i.e., #2).
IMPORTANT: Do not shift on slopes. Choose
a slow speed so that you will not have to stop
or shift while on the slope.

Stopping the Machine

To stop the machine, depress the clutch/brake pedal,
shift into neutral, disengage the blade control (PTO),
and turn the ignition key to "OFF" to stop the engine.
Also set the parking brake if you leave the machine
unattended; refer to Setting the Parking Brake,
page 12. Remember to remove the keys from the
ignition and Key Choice switches.
POTENTIAL HAZARD
Someone could move or attempt to operate
the tractor while it is unattended.
WHAT CAN HAPPEN
Children or bystanders may be injured if
they use the tractor.
HOW TO AVOID THE HAZARD
Always remove the ignition and "Key
Choice" keys and set the parking brake
when leaving the machine unattended, even
if just for a few minutes.
IMPORTANT: Do not "Ride the Brakes".
Shift to a lower speed for slower ground
speed. Choose a slow speed so that you will
not have to stop or shift while on the slope.
Operation
19