Weston 01-0201 Manual page 6

BEATER & CHOPPER ASSEMBLY
1. Align the notches on the Base Plate
with the groves on the inside of the Mixing
Container. Slide the Base Plate into the
Mixing Container so that is sits flat in the
bottom of the Mixing Container (FIGURE E).
2. Place the Beater or Chopper Attachment
onto the post of the Base Plate in the bottom
of the Mixing Container (FIGURE F).
CAUTION! Handle the 3 Blade Chopper
Attachment by the plastic portion only.
Blades are very sahrp!
3. Align the Attachment with the post on the
Mixing Lid (FIGURE F).
4. Place the assembled Mixing Lid onto the
Mixing Canister.
5. Align the grooves in the Mixing Handle
with the splines on the Mixing Lid. Push the
Mixing Handle firmly down (FIGURE G).
6. The Beater (FIGURE H) or the Chopper
(FIGURE H1) is now ready for use.
WARNING
SHARP BLADES!
Protective/cut-resistant
gloves are
recommended
whenever handling the
3 Blade Attachment!
6
FIGURE H1
Base Plate
Mixing Container
FIGURE H
Splines
Mixing Lid
FIGURE E
Notches
Grooves
FIGURE F
Post for Beater or
3 Blade Chopper
Attachments
Underside of
Mixing Lid
Beater
Attachment
Mixing Container
Mixing Handle
FIGURE G