Setup; Installing The Handle - Toro 22188 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Handle
Bolt (5/16 x 1-1/4 inches)
Washer
Thin locknut (5/16 inch)
1
Bolt (5/16 x 1-1/2 inches)
Locknut (5/16 inch)
Bag support rod
Cap locknut
Cable tie
Self-tapping screw
2
Fuel tank
3
Discharge tunnel plug
4
No parts required
Note: Determine the left and right sides of the
machine from the normal operating position.
Step
1

Installing the Handle

Parts needed for this step:
1 Handle
2 Bolt (5/16 x 1-1/4 inches)
4 Washer
2 Thin locknut (5/16 inch)
2 Bolt (5/16 x 1-1/2 inches)
2 Locknut (5/16 inch)
1 Bag support rod
2 Cap locknut
1 Cable tie
Procedure
1. Mount the handle to the outside of the lawn
mower housing (using the bottom hole) with 2
bolts (5/16 x 1-1/4 inches), washers, and thin
locknuts (5/16 inch) (Figure 3).
Description
1. Handle latch
2. Bag support rod
2. Secure the handle latches to the handle with
8
Qty.
1
2
4
2
2 Install the handle.
2
1
2
1
2
Install the fuel tank and fuel line.
1
1 Install the discharge tunnel plug.
–
Fill the crankcase with oil.
Figure 3
3. Cap locknut (2)
4. Handle
2 bolts (5/16 x 1-1/2 inches), washers, and
locknuts (5/16 inch) (Figure 3).
Note: You can adjust the handle height
for comfortable operation. Stand behind the
handle to determine the height. To adjust the
handle height, position the cap screws and the
locknuts that secure the handle latches to the
handle into the other mounting holes in the
latches.
Use