EnGenius DuraFon-UHF-HC User Manual page 15

remaining.
● Indicates charging when in charger cradle.
d. The second and third lines of the LCD, maximum 14 characters each,
display status, message, menu selections, or user-editable alphanumerical
characters.
e. The last line displays the left and right soft keys.
2. Ringer
a. Rings to an incoming call.
b. Distinctive alert sounds indicate various events:
● Single beep: successful key entry
● Double beep: failed operation or invalid key entry; also, power on/off
● Periodic 1-Long-2-Short beeps (every 1 minute): low battery warning
● Periodic Long Series of beeps (repeat every 30 seconds): on-hold call
alert
3.
TALK/FLASH (
a. Places or answers a telephone or intercom call
b. Sends a flash signal to phone line to retrieve a dial tone after the call ends,
or to perform the call waiting feature provided by local phone companies
during a call.
c. Enables/disables speakerphone when held for one second.
4.
SPEAKERPHONE (
Press to enable/disable the speakerphone during incoming, outgoing or
intercom calls.
5.
2-WAY INTERCOM (
Places an intercom call to another handset ID or group ID (group paging).
Intercom calls are digital, full-duplex, and are conducted without the
assistance from the base.
6. PTT (Push-to-Talk)
a. Activate half-duplex broadcasting via UHF (ultra high frequency) band or
900MHz band
b. Press the Mode key repeatedly to set the desired channel (1–5) in
advance.
7.
Left/Right Soft Keys(
Make menu selection.
)
)
)
)
/
~15~