Table of Contents
Advertisement
36 inch Mower Deck shown
4. The measurement should be 4 inch (101.6 mm).
5. If it does not measure correctly:
A. Adjust the rear tire pressure.
B. Adjust the caster fork spacers.
C. Adjust the front mower deck support pins.
6. Check the carrier frame front-to-rear pitch.
Replacing the Grass Deflector
WARNING
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator's or
bystander's direction and result in serious injury.
Also, contact with the blade could occur.
Never operate the lawn mower unless you install a
cover plate, a mulch plate, grass deflector or bagger.
1. Remove the locknut, bolt, spring and spacer holding
the deflector to the pivot brackets (Figure 72). Remove
the damaged or worn grass deflector.
Figure 71
6 2
1
g015594
1. Bolt
2. Spacer
3. Locknut
4. Spring
2. Place the spacer and spring onto the grass deflector.
Place one J end of the spring behind the deck edge.
Note: Make sure one J end of the spring is installed
behind the deck edge before installing the bolt as
shown in Figure 72.
3. Install the bolt and nut. Place one J hook end of the
spring around the grass deflector (Figure 72).
Important: The grass deflector must be able
to rotate. Lift the deflector up to the full open
position and ensure that it rotates into the full
down position.
42
4
7
3
Figure 72
5. Spring installed
6. Grass Deflector
7. J hook end of spring
5
Advertisement
Table of Contents
