Table of Contents
Advertisement
Positioning the Seat
Position the seat where you have the best control of the
machine and are most comfortable
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, adjust the height
of the anti-scalp rollers.
Note: Adjust the anti-scalp rollers so the rollers do not touch
the ground in normal, flat mowing areas.
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral lock position and
set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Adjust the anti-scalp rollers as shown in
match the closest height-of-cut position.
G010233
3
1
1. Anti-scalp roller
2. Bolt
(Figure
19).
Figure 19
Figure 20
4
2
Figure 20
3. Flange nut
4. Hole spacing
Adjusting the Motion-Control
Levers
Adjusting the Height
You can adjust the motion-control levers higher or lower for
maximum comfort
A
g027252
Adjusting the Tilt
You can adjust the motion-control levers forward or rearward
for your comfort.
1. Loosen the upper bolt holding the control lever to the
control-arm shaft.
2. Loosen the lower bolt just enough to pivot the control
lever forward or rearward
3. Tighten both bolts to secure the control lever in the
new position.
4. Repeat the adjustment for the other control lever.
to
21
(Figure
21).
B
Figure 21
(Figure
21).
Advertisement
Table of Contents
