Stopping The Machine; Adjusting The Height Of Cut - Toro 74750 Operator's Manual

Stopping the Machine

To stop the machine, move the motion-control levers to
the N position and outward to the P
EUTRAL
disengage the blade-control switch, ensure the throttle is at
full throttle, and turn the ignition key to off. Remove the
key from the ignition switch.
WARNING
Children or bystanders may be injured if they
move or attempt to operate the mower while it is
unattended.
Always remove the ignition key and move the
motion-control levers outward to the P
when leaving the machine unattended, even if just
for a few minutes.

Adjusting the Height of Cut

Note: The transport position is the highest height-of-cut
position, position or cutting height 115 mm (4.5 inches) as shown in
ARK
Figure
Height of cut is controlled by the lever located to the right of
the operating position
position
ARK
20
18.
(Figure 18).
Figure 18