Electrical Connection - Zanussi ZFX31400WA User Manual

1. Remove the top hinge cover.
2. Unscrew the 2 retaining screws, and
remove the hinge from the appliance.
4
3. Take the door off.
4. Unscrew the two screws fixing the lower
door hinge (there is a foot fixing on the
hinge, do not remove it from the hinge).
Take the door off.
2
5. Then remove the left foot as shown in the
figure.
6. Fix the door hinge (with the original foot
on it) on the opposite side and then the
loosened foot at the former place as
shown in the figure.
Make sure to place the screws in the right
holes as shown in the figure.The edge of the
hinge is parallel with the side of the cabinet.
Please make sure to place the lower
foot below the door hinge. The lower
foot is recognizable by its 4 ribs on the
outer surface.
7. Fix the door onto the lower hinge pin.
8. To fit top door hinge, remove the plastic
screw hole cover carefully, and refit them
in the holes left by the hinge retaining
screws.
32
www.markabolt.hu
1
3
2
1
1
9. Refit the top hinge using the 2 retaining
screws, making sure that the edge of
the door is parallel with the side of the
cabinet.
10. Replace the hinge cover.
11. Relocate the handle and the plastic plugs
to the opposite side.
1
WARNING! Reposition, level the ap-
pliance, wait for at least four hours and
then connect it to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the
cabinet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting
of the gasket.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The After
Sales Service specialist will carry out the
reversibility of the doors at your cost.

Electrical connection

• Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
• The appliance must be earthed. The power
supply cable plug is provided with a con-
tact for this purpose. If the domestic power
supply socket is not earthed, connect the
appliance to a separate earth in compliance
with current regulations, consulting a quali-
fied electrician.
• The manufacturer declines all responsibil-
ity if the above safety precautions are not
observed.
• This appliance complies with the E.E.C.
Directives.
2
3
www.zanussi.com