Cleaning And Storage - Toro ProLine 30187 Operator's Manual

Maintenance

Cleaning and Storage

1. Disengage the power take off (PTO) and turn the
ignition key to "OFF" to stop the engine.
Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially
the engine. Clean dirt and chaff from the outside
of the engine's cylinder head fins and blower
housing.
IMPORTANT: You can wash the machine
with mild detergent and water. Do not
pressure wash the machine. Avoid excessive
use of water, especially near the control panel,
engine, hydraulic pumps and motors.
3. Service the air cleaner; refer to Air Cleaner,
page 22.
4. Change the crankcase oil; refer to Engine Oil,
page 23.
5. Change the hydraulic fluid; refer to Hydraulic
System, page 29.
6. Remove the spark plug(s) and check its
condition; refer to Spark Plug, page 25. With the
spark plug(s) removed from the engine, pour two
tablespoons of engine oil into the spark plug
hole. Now use the starter to crank the engine and
distribute the oil inside the cylinder. Install the
spark plug(s). Do not install the wire on the
spark plug(s).
7. Check the tire pressure; refer to Tire Pressure,
page 27.
38
8. For long-term storage (more than 90 days) add
stabilizer/conditioner additive to fuel in the tank
(1 oz. per gallon).
A. Run engine to distribute conditioned fuel
through the fuel system (5 minutes).
B. Stop engine, allow to cool and drain the
fuel tank; refer to Fuel Tank, page 28, or
operate engine until it stops.
C. Restart engine and run until it stops.
Repeat, on "CHOKE" until engine will not
restart.
D. Dispose of fuel properly. Recycle as per
local codes.
Note: Do not store stabilizer/conditioned
gasoline over 90 days.
9. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged or
defective.
10. Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service
Dealer.
11. Store the machine in a clean, dry garage or
storage area. Remove the key from the ignition
switch and keep it in a memorable place. Cover
the machine to protect it and keep it clean.