Assembly; Loose Parts; Installing The Handle; Installing The Discharge Chute - Toro 38172 Operator's Manual

Assembly

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts

Description
Upper handle section
Handle knobs
Oval-head bolts
Curved washers
Locknuts
Washers
Knob
Discharge chute
Ignition key
Power cord (electric-start model only)

Installing the Handle

1. Position the ends of the upper handle section on the
inside of the lower handle section and align the holes
(Fig. 2).
5
Figure 2
1. Handle knob (2)
2. Lower handle section
3. Oval-head bolt (2)
2. Insert the oval-head bolts into the aligned holes in the
handle sections with the bolt heads on the outside of the
handle (Fig. 2).
3. Install the curved washers and the handle knobs on the
oval-head bolts and tighten the handle knobs securely.
1
4
3
2
m–4022
4. Upper handle section
5. Curved washer (2)
Qty.
1
2
Installing the handle
2
2
2
2

Installing the discharge chute

1
1
1 Starting and stopping the engine
1 Starting the engine
Note: Ensure that the oval-head bolts and the curved
washers are properly installed (See inset in Fig. 2).
Installing the Discharge Chute
1. Position the holes in the sides on the discharge chute
over the two hex bolts on the sides of the chute handle
(Fig. 3).
1
2
3
1. Discharge chute
2. Hex bolt (2)
3. Washer (2)
2. Secure the discharge chute onto the hex bolts with two
washers and two locknuts (Fig. 3).
3. Rotate the discharge chute to the upright position.
4. Install the knob tightly onto the screw at the rear of the
discharge chute (Fig. 3).
7
Use
4
5
6
Figure 3
4. Chute handle
5. Knob
6. Locknut (2)