Filling The Engine With Oil; Assembling The Grass Bag - Toro Recycler 20370 Operator's Manual

3

Filling the Engine with Oil

No Parts Required
Procedure
Your machine does not come with oil in the engine.
1. Remove the dipstick
2. Slowly pour oil into the oil-fill tube until the oil level
reaches the Full line on the dipstick
overfill. (Max. fill: 0.53 L (18 oz), type: 10W-30 or
SAE 30 detergent oil with an API service classification
of SJ or higher.)
Note: Each time you check the oil level, remove the
dipstick and wipe it clean, insert it into the oil filler
neck (but do not screw it in), then remove it again and
check the level (Figure
Note: If you overfill the engine, pour some oil out of
it; refer to Changing the Engine Oil (page
3. Install the dipstick securely.
Important: Change the engine oil after the first 5
operating hours ; change it yearly thereafter. Refer
to Changing the Engine Oil (page
4

Assembling the Grass Bag

No Parts Required
Procedure
1. Slip the grass bag over the frame as shown in
(Figure 5).
Figure 5
(Figure 5). Do not
5).
13).
13).
1. Handle
2. Frame
Note: Do not slip the bag over the handle
2. Hook the bottom channel of the bag onto the bottom
of the frame
3. Hook the top and side channels of the bag onto the top
and sides of the frame, respectively
Figure 6.
5
1
3
2
Figure 6
3. Grass bag
(Figure 7).
Figure 7
g027120
(Figure 6).
g027121
(Figure 7).