Onkyo TX-NR808 Instruction Manual page 81

8
When you have a network connection, select
the brand name again, and then press ENTER.
When you do NOT have a network connection,
use q/w to select the brand name, and then
press ENTER.
The following screen appears.
8–1. Remote Mode Setup
Category
Brand
Model
Skip
Search by model number( via network )
9
The AV receiver accesses and searches the
database. Select "Search by model number( via
network )", and then press ENTER. When you
do NOT have a network connection, select
"Skip" when you don't want to select the
model, and then press ENTER.
If you select "Skip", you will go to step 11.
10
Enter the model in a similar manner as in the
case of the brand name (step 6).
Tip
• After entering the 3rd character, press ENTER to start
searching.
• You cannot enter a space character.
11
Use q/w to select the model, and then press
ENTER.
If the brand name is not found, use r to select
"Not Listed", and then press
After searching is completed, a message for
remote control code transfer will appear.
8–1. Remote Mode Setup
Category
Brand
Model
Now we are ready to transfer data to remote.
Please hold remote so that it is facing the receiver.
Ready?
OK
12
While pointing the remote controller at the AV
receiver's remote control sensor, press ENTER.
Remote control sensor (Transmitter)
Incoming sensor
15° off center
(Left/Right/Up/Down)
TV
TV
Sonic
(Option)
.
ENTER
TV
TV
XXXXX
xxxxx[***/***]
15
15
Approx.
16ft. (5 m)
13
When you have a network connection, a mes-
sage "Successful" will appear. Now the transfer
is successful!
You'll return to the category selection menu.
Press SETUP to end the remote mode setup.
When you do NOT have a network connection,
the following screen appears.
Push any key (except for arrow buttons and
ENTER) to see if the component responds.
8–1. Remote Mode Setup
Category
Brand
Code
1. Push some key to see if the TV responds.
(except Arrow and Enter.)
2. Choose "Works" or "Doesn't work".
*
Works
Doesn't work (Try next code)
* When category other than TV have been selected,
the content is different.
14
If you can control component, press
RECEIVER, use q/w to select "Works", and
then press ENTER.
8–1. Remote Mode Setup
Category
Brand
Code
Now we are ready to transfer data to the remote.
Please hold the remote so that it is facing the receiver.
Use ENTER button of your remote to activate "OK".
Ready?
OK
If you cannot control component, use q/w to
select "Doesn't work (Try next code)" and
press ENTER.
The next code appears.
15
Press ENTER to transfer the determined code.
Remote control sensor (Transmitter)
Incoming sensor
15° off center
(Left/Right/Up/Down)
16
Press ENTER.
You'll return to the category selection menu.
Press SETUP to end the remote mode setup.
TV
TV
XXXXX
xxxxx[***/***]
TV
TV
XXXXX
xxxxx[***/***]
15
15
Approx.
16ft. (5 m)
En
81