Assembly; Loose Parts; Installing The Auger/Impeller Housing - Toro 38079 Operator's Manual

Assembly

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts

DESCRIPTION
Flange-head bolts—3/4 in. (1.9 cm)
Lower belt cover
Flange-head bolts—1/2 in. (1.3 cm)
Cable cover
Shift rod
Locknuts
Discharge chute
Worm gear
Gear bracket
Carriage bolt
Flat washer
Locknut
Skids
Flange-head bolts—3/4 in. (1.9 cm)
Flat washers
Locknuts
Ignition key
Installing the Auger/Impeller
Housing
1. Remove the 2 flange-head bolts that secure the idler
pulley assembly to the engine frame, and remove the
idler pulley assembly (Fig. 2).
QTY.
6
1

Installing the auger/impeller housing

Installing the auger/impeller housing
5
1
1
Installing the shift rod Installing the shift rod
2
1 Installing the discharge chute
1
1
1 Installing the chute control gear
1
1
2
2
Installing the skids I t lli th kid
2
3
1 Starting and stopping the engine
1
2
3
4
1. Idler pulley assembly
2. Flange-head bolts
3. Impeller pulley
Important
Remove the idler pulley assembly to
prevent damaging it.
8
USE
5
163
Figure 2
4. Engine frame
5. Auger housing