Adjusting The Handle Height; Starting The Engine; Using The Self-Propel Drive; Stopping The Engine - Toro Super Recycler 20792 Operator's Manual

Adjusting the Handle Height

You may raise or lower the upper handle to a position
comfortable for you.
Rotate the handle lock, move the handle to 1 of 3 positions,
and lock the handle into position (Figure 12).
Figure 12

Starting the Engine

1. Pull the blade-control bar to the handle (Figure 13).
Figure 13
2. Pull the recoil-start handle (Figure 14).
Note: If the machine does not start, contact an Authorized
Service Dealer.

Using the Self-propel Drive

To operate the self-propel drive, simply walk with your hands
on the upper handle and your elbows at your sides, and the
machine will automatically keep pace with you (Figure 15).

Stopping the Engine

Service Interval: Before each use or daily—Ensure that
the engine stops within 3 seconds after
releasing the blade-control bar.
To stop the engine, release the blade-control bar (Figure 16).
Important: When you release the blade-control bar,
both the engine and blade should stop within 3 seconds.
If they do not stop properly, stop using your machine
immediately and contact an Authorized Service Dealer.
9
Figure 14
Figure 15
Figure 16