Removing The Mower - Toro 74824 Operator's Manual

8. Remove the belt from the mower deck pulleys and
remove the existing belt.
9. Install the new belt around the mower pulleys and
the clutch pulley under the engine (Figure 66).
The spring is under tension when installed and
can cause personal injury.
Be careful when removing the belt.
10. Using a spring removal tool, (Toro part no. 92-5771),
install the idler spring over the deck post and
placing tension on the idler pulley and mower belt
(Figure 66).
11. Ensure that the belt is properly seated in all pulleys.
12. Install the belt covers (Figure 67).
1. Position the belt cover,
ensure the tabs seat
2. Pivot the belt cover down

Removing the Mower

Park the machine on a level surface and disengage the
blade control switch. Move the motion control levers
outward to the neutral position, engage parking brake,
stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
Lower the mower to the 3 inch (76 mm) height-of-cut
position. Remove the mower belt from the engine
pulley; refer to the Replacing the Mower Belt procedure.
Lower the mower to the lowest height-of-cut. Select one
1
3
G010343
Figure 67
3. Install the screws
of the following procedures depending on the mower
deck size installed to complete the removal.
1. Remove the hair pin cotter and washer securing the
long, link bar to the frame and deck; remove the link
bar (Figure 68).
1
2
1. Hair pin cotter
2. Washer
2. Remove the hardware from the front and rear deck
hangers on both sides of the deck (Figure 69).
4
1. Deck hanger
2. Hairpin cotter
3. Raise the height-of-cut to the transport position
4. Slide the mower out from underneath the machine.
Note: Retain all parts for future installation.
46
2
G010309
Figure 68
3. Link bar
1
2
4
3
G010305
Figure 69
3. Washer
4. Welded post on deck
3
1
2
3