Servicing The Air Cleaner - Toro 30433 Operator's Manual

If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the spark plug wire from the spark plug(s)
before you do any maintenance. Set the wire aside so that it does not accidentally contact the
spark plug.

Servicing the Air Cleaner

Service Interval/Specification
Foam Element: Clean and re-oil after every 25 operating
hours.
Paper Element: Clean after every 25 operating hours.
Replace after every 100 operating hours.
Note: Service the air cleaner more frequently if operating
conditions are extremely dusty or sandy.
Removing the Foam and Paper Elements
1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to off. Remove the
key.
2. Clean around the air cleaner to prevent dirt from
getting into the engine and causing damage. Unscrew
the cover nut and remove the air cleaner cover
(Fig. 21).
3. Remove the air cleaner assembly (Fig. 21).
4. Carefully slide the foam element off the paper element
(Fig. 21).
Caution
1
4
5
1. Cover and nut
2. Wing nut
3. Foam element
Cleaning the Foam Elements
1. Wash the foam element in liquid soap and warm water.
When the element is clean, rinse it thoroughly.
2. Dry the element by squeezing it in a clean cloth.
3. Put one or two ounces of oil on the element (Fig. 22).
Squeeze the element to distribute the oil.
Important Replace the foam element if it is torn or
worn.
27
2
3
6
Figure 21
4. Washer and grommet
5. Paper element
6. Air cleaner base
m–2595