Installation; Working Angle And Range Of The Ir Blaster - Onkyo RFR-5 Instruction Manual

Installation

The following components should be present: RF
Receiver, power adapter, 3 IR emitters, Mono
cable and 4 screws.
Before you install the RF Receiver, you should
decide which of the set-ups described on p. 2
apply to your needs. It is recommended to read
through the entire User Guide.
Working Angle and Range of the
IR blaster
Note:
The IR signals sent out by the RF Receiver always
have to be able to reach the receiving eyes of your
devices. Make sure that the IR blaster (dark
plastic window on top of the RF Receiver) is
aimed at your devices.
To get optimal results, it is recommended to place
the RF Receiver horizontally with the IR blaster
facing up or down.
Minimum distance: 4 inches
(10 cm)
Figure 1: IR blaster facing down
Figure 1 represents the RF Receiver mounted up
side down inside a closet. Always maintain a
minimum distance of 4 inches (10 cm) between
the RF Receiver and your devices.
Maximum distance: 16 feet (5 m)
Figure 2: IR blaster facing up
Figure 2 represents the RF Receiver with the IR
blaster facing up. The RF Receiver can be placed
at a distance and higher than your devices. Make
sure there are no objects between the RF Receiver
and the receiving eyes of the devices.
5