Toro 30857N Operator's Manual page 30

•
Steering-cylinder ball joints (2) (Figure 23)
1. Top fitting on kingpin
•
Tie-rod ball joints (2) (Figure 23)
•
Kingpin bushings (2) (Figure 23). The top fitting on
the king pin should only be lubricated annually
(2 pumps).
•
Lift-arm bushings (1 per deck) (Figure 24)
•
Lift-cylinder bushings (2 per deck) (Figure 24)
Figure 23
Figure 24
•
Cutting-unit spindle-shaft bearings (2 per cutting unit)
(Figure 25)
Note: Either fitting can be used, which ever is more
accessible. Pump grease into the fitting until a small
amount appears at bottom of the spindle housing (under
the deck).
•
Cutting-unit carrier-arm bushings (1 per cutting unit)
(Figure 25)
•
Rear roller bearings (2 per cutting unit) (Figure 26 )
Important: Make sure that the grease groove in
each roller mount aligns with the grease hole in each
end of the roller shaft. To help align the groove and
the hole, there is also an alignment mark on 1 end of
the roller shaft.
30
Figure 25
Figure 26