Identification And Ordering - Toro 30722 Operator's Manual

hole location.
8. Tension the idler pulleys against all three belts. Also install the
covers tothe top of the cutting unit.
9. Set the rear caster wheels in the lower holes in the caster forks
if height-of-cut is above 25 mm and adjust height of cut.
10. Mount the cutting unit to the traction unit: refer to Mounting
Cutting Unit To The Traction Unit.

IDENTIFICATION AND ORDERING

MODEL AND SERIAL NUMBERS
The cutting unit has two identification numbers: a model number
and a serial number. These numbers are stamped into a plate. The
cutting unit identification plate is located just ahead of the left rear
caster wheel (Fig. 16). In any correspondence concerning the cut-
ting unit, supply the model and serial numbers to assure correct
information and replacement parts are obtained.
To order replacement parts from an authorized TORO Distributor,
supply the following information:
1. Model and serial numbers of the cutting unit.
2. Part number, description and quantity of parts desired.
SERVICE INTERVALS
Lubricate Caster Arm Bushings
Lubricate Caster Wheel Bearings
Tighten Castor Wheel Nuts
(Tighten after 2 & 10 hrs. initially)
Torque Blade Bolts
(Tighten after 10 hrs. initially)
Lubricate Grease Fittings
Clean The cutting Unit
Check Blade Drive Belts
Check Gear Box Oil
Change Gear Box Oil
Figure 16
1. Cutting unit model and serial number
Daily
Daily
Daily
50 hours
50 hours
50 hours
50 hours
50 hours
50 hours
50 hours
250 hours
19