Tascam BD-01U Owner's Manual page 15

13. h (reverse) button
• During playback, press to fast reverse the playback.
B (play) button*
• Press to start playback or resume playback.
g (forward) button
• During playback, press to fast forward the playback.
• In pause mode, press to slow forward the playback.
H (skip) button
• During playback, press once to return to the
beginning of the current title, chapter, track or file.
• During playback, press twice to return to the
previous title, chapter, track or file.
• During JPEG playback, press to return to the previous
file.
C (stop) button
• Press to stop playback.
k (pause) button
• Press to pause playback.
• When playback is in pause mode, press to forward
playback frame by frame.
G (skip) button
• During playback, press to skip to the next chapter,
track or file.
14. AUDIO button
• Press to select the audio channel (such as audio
languages) on a disc.
15. SUBTITLE button
• Press to select subtitles on a disc.
16. DIMMER button
• Press to dim the panel display.
17. REPEAT button
• Press to select repeat modes.
18. A-B button
• Press to play back a defined section between point A
and B repeatedly.
19. ON SCREEN button
• Press to display the on-screen display menu.
EN
■ Installing the Batteries in the Remote Control
Install 2 AAA(R03) (1.5V) batteries matching the polarity
indicated inside battery compartment of the remote control.
@Caution
Incorrect use of batteries can result in hazards such as
leakage and bursting. Please observe the following:
• Use alkaline or standard (carbon-zinc) batteries.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
Although they may look similar, different batteries may
have different voltages.
• Make sure that the + and - ends of each battery match
the indications in the battery compartment.
• Remove batteries from battery compartment, when the
remote is not going to be used for a month or more.
• When disposing of used batteries, please comply with
governmental regulations or environmental public rules
that apply in your country or area.
• Do not recharge, short-circuit, heat, burn or disassemble
batteries.
■ Using the Remote Control
Remote Control Usage Guidelines:
• Make sure that there are no obstacles between the remote
control and the infrared sensor window on the unit.
• Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the infrared
sensor window of the unit.
• Remote controls of different devices can interfere with
each other. Avoid using a remote controls of another
device which is located close to the unit.
• Replace the batteries when you notice a fall-off in the
operating range of the remote control.
• Direct the remote control straight to the infrared sensor
window on the unit.
- Line of sight:
approx. 23 feet (7m)
- Either side of the center:
approx. 16 feet (5m) within 15°
15