fig. 15
Changing the rear
window blade
Proceed as follows:
❒ raise the cover A-fig. 15 and remove
the arm from the car, slackening the nut
B that fastens it to the pivot pin;
❒ fit the new arm, positioning it correct-
ly, and fully tighten the nut;
❒ lower the cover.
F0Q0663m
fig. 16
SPRAY NOZZLES
Windscreen wiper fig. 16
If the jet of fluid is inadequate, firstly check
that there is fluid in the reservoir: see
"Checking fluid levels" in this section).
Then check that the nozzle holes are not
clogged, if necessary use a needle.
The windscreen jets are fixed.
F0Q0661m
fig. 17
Rear window wiper fig. 17
Rear window washer jets are fixed.
The nozzle holder is on the rear window.
F0Q0660m
207